Jump to content
Sign in to follow this  

I have questions you have answers

Recommended Posts

Hello current and former Taurus / Sables owners once again I'm here to ask some much needed questions. Only electrical questions. I'm doing a lot of mods to my 97 Sho and  I need your help to finish it.

A little  later I am going to make a build log to show my process and completion.

I have remove the battery sometime ago and removed the floor shift. At the moment I'm at work and not near my car.

1 I'm installing a backup cam in the rear of the car and would like to know which  is the reverse wire  or wiring color.

2 For the 3rd brake light I need to know which is the positive and negative wires so i can install  my gen 4 Taurus leds.

3 Where should the resistor be put on the gen 4 led 3rd brake light board. 

4 Installing  a gentex 453 mirror that has auto dim, compass homelink and I want to wire it to the A pillar wiring. I need to know which wires are constant switches and negative. 

5 I was on  v8sho forum and read  there was a unused 12 volt plug  in the dash. Has anyone used this plug. I removed  a switch from a gen 3 wagon and only want to use the connector.  This is because I  want  to wire it  to my wireless charger.  Does anyone  know the wire polarity  of the unused 12 volt  plug.

6 I have a 96 cluster  from a Sho and plug and wiring for the led shift indicator lights. I would like to know how can I wire it so the cluster and floor  shift  read the same.

7 Can a 96 degas tank and washer fluid tank both with sensors  be wired to my 96 sho cluster in the 97 sho. How  would this be done and wired to the cluster.

8 How to wire the oem under dash courtesy lights in a car that doesn't have  them.

9 How do you  wire Lincoln nav power folding  mirror switch to the door for the Ghia mirrors.

10  If I got front  door panel wiring harnesses from a 96 Sable  with the key pad and  courtesy door lighting is it plug and play.

11 What is an easy way to replace door led with a different  color. I ordered  to led bulb sizes 5 mm and 3mm.

12 Will my power antenna still work if I use my carpc instead of factory  rcu.

13 How to install an antenna  switch. 

14  Can I remove factory rcu without  having problems.

Any help  would  be greatly  appreciated. 

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.