Jump to content
Sign in to follow this  

2003 part out

Recommended Posts

It's been four years and I have yet to replace the transaxle in my 2003 spruce green metallic clearcoat SES. 

I don't have current pictures.  The vehicle is located at a friend's house.  It has been started every couple of weeks to keep the engine up.  

The AXOD trans is shot. The fluid pump explode inside. The Vulcan engine is probably still good.  It's a 2003 with 135,000 miles. 

I'll be headed over to the car in a few weeks to take some pictures.   There was very little body rust when I last saw it.  I have service records on request.   It has sat outside for over four years.   

Before the trans failed, I had replaced the ball joints, tie rods brakes, front wheel bearings, parking brake cable and tires. The struts/springs were also less then a year old too.  

It's an SES, however I added the following. 

  • Keypad
  • Autolamps
  • footwell lights
  • Continental shifter 
  • ignition lock shroud deleted
  • updated coolant cap
  • "security" flasher enabled on sunload sensor
  • added extra light fixtures to trunk, and a cut off switch for loading
  • replaced coolant bottle with one from a 2004. 
  • replace stabilizer bar bushings.  Used clamp from a Gen 3.

Extra parts that didn't get to be installed. 
Gen 4.5 tails for amber turn mod + associated wires
Woodgrain radio trim 
Gen 4 Wagon Liftgate release
Extra headlamp switches 
More parts to be added as I find them. 

Sent from my SM-N950U using Tapatalk

Share this post

Link to post
Share on other sites
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.